Date:10/23/2009 ID:faq000336_002




Title:

I replaced my ink cartridge, but the LCD is still displaying "Ink Empty".  What can I do?

Description:

This is typically caused by an incorrect selection made during the LCD prompts after a cartridge is replaced, or the hook did not snap securely over the ink cartridge when it was installed. Do the following to clear the message:

Note

If the LCD displays "No Cartridge", click here to check how to clear the message.


 


  1. Open the Scanner Cover by lifting from the right-hand side of the machine until it locks securely into the open position.
image
  1. Pull the ink cartridge hook toward you and remove the ink cartridge for the color shown on the LCD. Reinstall the ink cartridge and press it down firmly until the hook snaps over it securely. Push the hook towards the cartridge to verify it is securely latched over the top edge of the cartridge.



    image


    image




    Note

    Please double check the following:
    Keep the ink cartridge in an upright position when you insert it into the slot. Press down FIRMLY on the top of the cartridge until it is fully seated. Push the white plastic hook towards the cartridge to verify it is fully latched over the cartridge's top edge.
image


 
 
  1. After installing the ink cartridges, lift the scanner cover to release the lock Gently push the scanner cover support down and close the scanner cover.
image
  1. The LCD may then display:
    Did you change Blck? 1.Yes 2.No.
    The LCD may display this question for the color(s) that was replaced.
    BE SURE to select 1 Yes. If 1 YES is not selected for the replaced cartridges, INK EMPTY will appear again.
  1. After all the correct selections are made, the machine will then go into cleaning mode. Once this is complete, the LCD will return to the date and time.

If the LCD displays "No Cartridge", there is a possibility that ink cartridges other than the ones you replaced are empty.

  1. Open the Scanner Cover by lifting from the right-hand side of the machine until it locks securely into the open position.


    image



  2. Check the LCD display while keeping the cover open. If you see the message "Change Cartridge Install xx", the color displayed at "xx" is empty. Please replace it.

If the message "No Cartridge" does not disappear, unplug the machine from the AC power outlet and wait approximately 10 seconds, and then plug it back in. If the date and time appear on the display, the problem is solved.

If you still have the same problem, please contact Brother Customer Service from "Contact Us".
If your question was not answered, please check...
  

  • Have you checked other FAQ's?

  • Is the answer in the user guide?

  • If you need further assistance, please contact Brother customer service:

Related Models

DCP-110C, DCP-120C, FAX-2440C, MFC-210C, MFC-420CN, MFC-620CN, MFC-640CW, MFC-820CW

Was the information on this page helpful?

Please indicate (above) if the information was helpful or not. If you have additional comments please enter them into the area below and click Submit.

Sorry, we cannot reply directly to your e-mail, but we will listen to your comments.

>Clear