CS-8150

Caution

1. Check that the thread cassette indicator is lit up in green.

   Thread cassette indicator

   
   
   
    

   Caution

   • If the thread cassette indicator is lit up in red, the needle has not been raised to the correct position. Press Needle position button once to raise the needle.
     
     

     Needle position button

     
     
   • If the needle is not raised to the correct position, the needle cannot be threaded with the needle threader. Be sure to check that the thread cassette indicator is lit up in green before inserting the thread cassette.
2. Insert the thread cassette into the thread cassette compartment.
   
   
   
    
3. Slowly press down on the thread cassette until it clicks into place.
   

   Push here  Press down the thread cassette until it clicks.

   
   
4. At the same time that the thread cassette is inserted, the needle is threaded.
   The thread cassette indicator goes off.
   

   Needle bar thread hooks

   
   
    

   Caution

   • If any of the following operations are performed, the needle may not be threaded or the machine may be damaged.

     Pushing the cassette down too fast	Pushing down on a part of the cassette other than the gray area

     
     

     Inserting the cassette only partway, then pulling it out	Inserting the cassette partway and pausing before fully inserting it

     
     
   • If the needle could not be threaded or the thread was not passed through the needle bar thread hook, refer to "How do I load the spool into the thread cassette?" and perform the procedure again starting from step 2.
     
     
   • The thread cassette can be inserted whenever the presser foot lever is raised or lowered. However, when the side cutter is attached, be sure to lower the presser foot lever before installing the thread cassette.
     
     
   • The needle threader will automatically thread the needle when the thread cassette is pushed down. Be sure to keep your hands and other items away from the needle, otherwise injuries may occur.
5. Carefully pull on the loop of thread passed through the eye of the needle to pull out the end of the thread.
   
   
    
6. Pass the thread through the presser foot, and then pull out about 10-15 cm (3/8-5/8 inch) of thread toward the rear of the machine.
   

   10-15 cm (3/8-5/8 inch)

   
   The upper threading is finished.
   
   
7. Close the thread cassette compartment cover.
   
   
   

   Caution

   • When inserting the thread cassette into its compartment, slowly press it down.
   • If the sewing machine could not be threaded, try performing the procedure again starting from loading the spool of thread into the thread cassette.