CP-7500

Sewing performance will suffer if dust collects in the bobbin case; therefore, it should be cleaned periodically.

1. Switch the machine off and unplug it.
   

        

    

2. Raise the needle and the presser foot.
   

        

          Mark on the handwheel       Presser foot lever

    

3. Loosen the presser-foot holder screw and the needle clamp screw to remove the presser-foot holder and the needle.
   

        

               Presser foot holder       Presser foot holder screw

               Needle clamp screw       Disc-shaped screwdriver

    

4. Slide the needle plate cover release toward you to remove the needle plate cover.
   

        

               Needle plate cover       Needle plate cover release

    

5. Remove the bobbin case.
   

               Bobbin case

    * Grasp the bobbin case, and then pull it out.

    

6. Use the cleaning brush or a vacuum cleaner to remove any dust from the race and its surrounding area.
   

        

               Cleaning brush       Race

    

   Caution

   Do not put oil on the bobbin case.

    

    

7. Insert the bobbin case so that the mark on the bobbin case aligns with the mark on the race.
   

        

        * Align the    and    marks.

    

        

                 mark         mark       Bobbin case

    

   Note

   Make sure that the indicated points are aligned before installing the bobbin case.

    

    

   Caution

   • Never use a bobbin case that is scratched, otherwise the upper thread may become tangled, the needle may break or sewing performance may suffer.
     For a new bobbin case (part code: XE7560-001), contact your nearest authorized service center.

      

   • Make sure that you fit the bobbin case properly, otherwise the needle may break.

    

8. As shown, insert the tab on the needle plate cover into the hole in the needle plate, and then correctly position of the needle plate cover.
   

        

               Needle plate cover       Tab       Hole

    

   Note

   Check that the needle plate cover is flush with the top surface of the machine.

    

    

9. From the front, slide the needle plate cover back into position.
   

               Needle plate cover

    

   Caution

   If the needle plate cover is not flush with the surface of the machine as shown below, remove the needle plate cover (step 4), and then install it again (steps 8 and 9).
   Sewing while the needle plate cover is not flush with the surface of the machine may cause the needle plate cover to come off of the machine, resulting in injuries if your fingers touch the race.