Home > USA/ Canada/ Latin America > United States >
Innov-is 1500D/1500 > FAQs & Troubleshooting > One Point > faqh000044_000
Refer to "Cleaning the case" for information on how to remove/install a bobbin case.
(2).Bobbin woundwith bobbin thread
(3).Embroidery pattern(will be downloadedin Procedure 4 below.)
(4).Fabric and embroidery frame
When you adjust an alternate bobbin case, turn a slotted-head(-) screw by a screwdriver(small).
If this occurs, turn the slotted-head screw (-) clockwise, being careful not to over-tighten the screw, approximately 30-45 degrees to increase bobbin tension.
If this occurs, turn the slotted-head screw (-) counterclockwise, being careful not to over-tighten the screw, approximately 30-45 degrees to decrease bobbin tension.
After adjusting an alternate bobbin case, make trial sewing to check thread tension. If the thread tension is still incorrect, repeat the Procedure 5 until you can obtain a correct thread tension.
Innov-is 1200, Innov-is 1500D/1500, Innov-is 2500D, Innov-is 4000D/4000, Innov-is 1250D, Innov-is 2800D, Innov-is 4500D, Innov-is 4750D, Innov-is 5000, Innov-is 6000D, Innov-is 6700D, Innov-is BP2100, Innov-is VE2200, Innov-is VM6200D
Sorry, we cannot reply directly to your e-mail, but we will listen to your comments.
Site Map |
Local Web Site |
Global Brother |
Copyright © Brother Industries, Ltd. All Rights Reserved.