Home > Europe > United Kingdom >
Innov-is 1250 > FAQs & Troubleshooting > Preparation > faqh000436_000
The order that the machine should be threaded for winding the bobbin is indicated by a broken line on the sewing machine. Be sure to thread the machine as indicated.
Turn on the sewing machine, and open the top cover.
Place the bobbin on the bobbin winder shaft so that the spring on the shaft fits into thenotch in the bobbin. Press down on the bobbin until it snaps into place.
Slide the bobbin winder in the direction of the arrow until it snaps into place.
("Start/Stop" button) lights up in orange.
Remove the spool cap that is inserted onto the spool pin.
Place the spool of thread for the bobbin onto the spool pin. Slide the spool onto the pin so that the spool is horizontal and the thread unwinds to the front at the bottom.
While holding the thread near the spool with your right hand, as shown, pull the thread withyour left hand, and then pass the thread behind the thread guide cover and to the front.
Pass the thread under the thread guide plate from the right.
Pass the thread under the hook on the thread guide, and then wind it counterclockwiseunder the pretension disk.
While holding the thread with your left hand, wind the thread that was pulled out clockwisearound the bobbin five or six times with your right hand.
Pass the end of the thread through the guide slit in the bobbin winder seat, and then pullthe thread to the right to cut it.
Be sure to cut the thread as described.
If the bobbin is wound without cutting the thread using the cutter built into the slit in the bobbin winder seat, the thread may become tangled in the bobbin and the needle may bend or break when the bobbin thread starts to run out.
Slide the sewing speed controller to the right to increase the bobbin winding speed and slide to left to decrease.
Press (“Start/Stop” button) once.
When the bobbin winding becomes slow, press ("Start/Stop" button) once to stop the machine.
Use scissors to cut the end of the thread wound around the bobbin.
Slide the bobbin winder shaft to the left.
Remove the bobbin from the shaft.
When the sewing machine is started or the handwheel is turned after winding the bobbin, the machine will make a clicking sound; this is not a malfunction.
Innov-is 1200, Innov-is 200, Innov-is 400, Innov-is 600, Innov-is 700E, Innov-is 700EII, Innov-is 100, Innov-is 1250, Innov-is 150SE/ 150, Innov-is 350SE, Innov-is 550SE/ 550, Innov-is 750E, NX-200, NX-400Q/400, NX-600
Sorry, we cannot reply directly to your e-mail, but we will listen to your comments.
Site Map |
Local Web Site |
Global Brother |
Copyright © Brother Industries, Ltd. All Rights Reserved.