Date:27/06/2006 ID:faqh000135_000




Title:
"Change the speed controller mode to "OFF"." appears on the LCD.

 

Description:
  • The start/stop button was pressed without connecting the foot controller
  • And the setting for adjusting the stitch width using the sewing speed controller is set to [ON].
  • You have selected a pattern for which width control cannot be used.

Note

    Each time a key is pressed or an incorrect operation is performed, a beep is sounded.

    • For a correct operation
      One beep is sounded.
    • If an incorrect operation is performed
      Two or four beeps are sounded.
    • If the machine locks up, for example, because the thread is tangled
      The sewing machine continues to beep for four seconds.
      The machine automatically stops.
      Be sure to check for the cause of the error, and correct it before continuing to sew.
If your question was not answered, please check...
  

  • Have you checked other FAQs?

  • Is the answer in the user guide?

  • If you need further assistance, please contact Brother customer service:

Related Models

CS-8120, Innov-is 1200, Innov-is 400, Innov-is 500D, Innov-is 600, Innov-is 100, Innov-is 1250, Innov-is 350SE, Innov-is 550SE/ 550, Innov-is 900, Innov-is 950, Innov-is 955, NX-400Q/400, NX-600

Was the information on this page helpful?

Please indicate (above) if the information was helpful or not. If you have additional comments please enter them into the area below and click Submit.

Sorry, we cannot reply directly to your e-mail, but we will listen to your comments.

>Clear