Date:15/11/2011 ID:faqp000397_000




Title:

How do I install/change the label roll?

Description:
To install a new label roll :
  1. Press the ON/OFF button to turn the QL-500/550 off. Hold the DK Roll compartment cover at the sides near the front of the QL-500/QL-550 and firmly lift up to open the cover.

  2. Place the spool into the spool guides in the DK Roll compartment (make sure that the spool arms are inserted firmly in the spool guides on the left and right sides. Insert the spool with the DK Roll located on the right hand side of the QL 500/550).

    Image

  3. Lift the label lever and then thread the end of the DK Roll into the slot immediately before the cutter (If you are unable to thread the end of the DK Roll into the slot, thread it as far as possible, lower the label lever and close the cover. Then press the FEED button to set the roll).

    Image

  4. Lower the label lever and then close the DK Roll compartment cover.


To remove a label roll :

  1. Press the ON/OFF button to turn the QL-500/550 off. Hold the DK Roll compartment cover at the sides near the front of the QL-500/QL-550 and firmly lift up to open the cover.

  2. Lift the label lever.

  3. Hold the label roll by the spool arms pull the inserted DK Roll up and out of the machine.

  4. Lower the label lever and then close the DK Roll compartment cover.
If your question was not answered, please check...
  

  • Have you checked other FAQ's?

  • If you need further assistance, please contact Brother customer service:

Was the information on this page helpful?

Please indicate (above) if the information was helpful or not. If you have additional comments please enter them into the area below and click Submit.

Sorry, we cannot reply directly to your e-mail, but we will listen to your comments.

>Clear