Date:04/07/2009 ID:faqh000465_000




Title:
How do I manually thread the needle?

Description:

When using special thread, thread with a thickness of 130/20 or thicker, the wing needle or the twin needle which cannot be used with the needle threader, thread the needle as described below.

 

 


  1. Thread the machine to the needle bar thread guide.

  2. Lower the presser foot lever.

    Lower the presser foot lever 1 Presser foot lever

  3. Pass the thread through the eye of the needle from front to back.

     
  4. Raise the presser foot lever, pass the end of the thread through the presser foot, and then pull out about 5 cm (2 inches) of thread toward the rear of the machine.
If your question was not answered, please check...
  

  • Have you checked other FAQs?

  • Is the answer in the user guide?

  • If you need further assistance, please contact Brother customer service:

Related Models

XL-5130/5232/5340, BM-3500/2600, BM-3600, Innov-is 1200, Innov-is 1500D/1500, Innov-is 200/200QE, Innov-is 400, Innov-is 600, Innov-is 700E, Innov-is 10, Innov-is 1000, Innov-is 1250, Innov-is 1250D, Innov-is 30, Innov-is 50, Innov-is 700EII, Innov-is 750E, Innov-is 900, Innov-is 950, NX-200/200QE, NX-250, NX-400Q/400, NX-450, NX-600, PX-100/200/300, QC-1000, XL-2120/2220/2230/2240, XL-2600/2620/2630, XL-5010/5020/5030, XL-5050/5060/5070, XL-5500, XL-5700

Was the information on this page helpful?

Please indicate (above) if the information was helpful or not. If you have additional comments please enter them into the area below and click Submit.

Sorry, we cannot reply directly to your e-mail, but we will listen to your comments.

>Clear