Date:25/02/2009 ID:faqh000020_000




Title:
There is looseness in the mounting jig when the fabric is placed in the cap frame/cylinder frame.

Description:
If there is looseness, follow the procedure described below to place the enclosed pad between the clamping pad of the thumb screw and the mounting surface.

  1. Position the mounting bracket onto the mounting surface (worktable, desk, etc.).
    Place the pad between the clamping pad of the thumb screw and the mounting surface (worktable, desk, etc.), and then firmly tighten the thumb screw.

    Place the pad between the clamping pad of the thumb screw and the mounting surface (worktable, desk, etc.)
    		  1 Mounting bracket

     2 Mounting surface (worktable, desk, etc.)

     3 Pad

     4 Tighten the thumb screw.

    Note

    When using an object other than the enclosed pad, use the following types of material.

    Non-slip sheet
    Rubber pad Non-slip sheet

  2. Check that there is no looseness. If the mounting jig is still loose, remove it, and then install it again.

    Caution

    • Make sure that the mounting bracket is securely clamped onto the mounting surface and that the thumb screw is firmly tightened.
    • Do not attach the mounting jig to an unstable surface (flexible, bent or warped).
    • Be careful that the mounting jig does not fall when it is removed.
If your question was not answered, please check...
  

  • Have you checked other FAQs?

  • Is the answer in the user guide?

  • If you need further assistance, please contact Brother customer service:

Related Models

PR-1000, PR1000e, PR-600/600C, PR-620/620C/600II/600IIC, PR-650/650C, PR650e/PR650eC

Was the information on this page helpful?

Please indicate (above) if the information was helpful or not. If you have additional comments please enter them into the area below and click Submit.

Sorry, we cannot reply directly to your e-mail, but we will listen to your comments.

>Clear