Date:25/02/2009 ID:faqh000012_000




Title:
The thread is looping when I try to wind a bobbin.

Description:

Looping while winding the bobbin could be caused by several reasons.

 


  • The thread may not be threaded through the thread guide properly.
    Rethread guide following the diagram on the machine.
    Be sure to pass the thread as far as possible into the two slits in the thread guide.
    Be sure to pass the thread as far as possible into the two slits in the thread guide.
    1 Thread guide for bobbin winding
    2 Two slits
  • The bobbin winder cover may not be pushed all the way open. When opening the bobbin winder cover, make sure it is push open as far as it will go.
    When opening the bobbin winder cover, make sure it is push open as far as it will go.
  • The thread could be winding off to quickly. When using threads such as transparent nylon thread or metallic threads, place the spool net over the spool before placing the spool of thread onto the spool pin.
    Place the spool net over the spool before placing the spool of thread onto the spool pin. 1 Spool net
    2 Spool
    3 Spool pin
    4 Spool cap

If your question was not answered, please check...
  

  • Have you checked other FAQs?

  • Is the answer in the user guide?

  • If you need further assistance, please contact Brother customer service:

Related Models

CS-8060, Innov-is 500D

Was the information on this page helpful?

Please indicate (above) if the information was helpful or not. If you have additional comments please enter them into the area below and click Submit.

Sorry, we cannot reply directly to your e-mail, but we will listen to your comments.

>Clear