Date:26/02/2009 ID:faqh000095_003




Title:
How do I clean the bobbin case?

Description:

 


  1. Remove the power plug from the outlet.
    Remove the power plug
  2. Raise the needle to its highest position, pull the latch and remove the bobbin case.
    remove the bobbin case
  3. Slide the latch levers out from the retaining ring.
    Slide the latch levers out

  4. Remove the retaining ring.
    Remove the retaining ring.
  5. Remove the hook by grasping the center post and pulling out.
    Remove the hook

    Note

    Note it’s position related to the driver.

  6. Remove any accumulated lint and thread with a brush.
    Remove any accumulated lint with a brush

    Note

    Clean the lint from the shuttle hook using a cloth dampened with machine oil.

  7. Grasp the center post of the hook, match the hook position opposite the driver and insert.
    Grasp the center post of the hook
  8. Insert the retaining ring with the notch up.
    Insert the retaining ring
  9. Push the latch levers into their locked position.Replace the bobbin cace.
    Push the latch levers
If your question was not answered, please check...
  

  • Have you checked other FAQs?

  • Is the answer in the user guide?

  • If you need further assistance, please contact Brother customer service:

Related Models

LS-2125/2160, LS-2150, XL-5500, XL-5700

Was the information on this page helpful?

Please indicate (above) if the information was helpful or not. If you have additional comments please enter them into the area below and click Submit.

Sorry, we cannot reply directly to your e-mail, but we will listen to your comments.

>Clear